How To Put Handles On Kitchen Cupboards

How to Install Kitchen Cabinet Handles

Installing new handles on kitchen cabinets can give them a fresh and updated look. Here's a step-by-step guide on how to do it:

Measure and Mark the Hole Locations

Begin by measuring and marking the hole locations for the handles. The standard spacing for cabinet handles is 3 inches from the top and bottom of the cabinet door. However, you can adjust this measurement to suit your preferences or the size of your cabinet doors.

Drill Pilot Holes

Once you've marked the hole locations, drill pilot holes at each mark using a drill bit that's slightly smaller than the diameter of the handle screws. Pre-drilling pilot holes helps prevent the wood from splitting when you drive in the screws.

Insert the Handles

Apply a small amount of wood glue to the back of each handle. Then, insert the handle into the pilot holes and align it with the markings. Secure the handle with the provided screws. Use a screwdriver or drill with a clutch setting to avoid overtightening.

Tighten and Adjust

Tighten the screws until the handle is securely attached. Check if the handle is level and make any necessary adjustments. You can loosen or tighten the screws as needed until the handle is perfectly aligned.

Additional Tips

Here are some additional tips for installing cabinet handles:

Use a level to ensure the handles are straight.
If the handles are too loose, add a washer or a small piece of wood between the handle and the door.
If the screws strip, try using a larger screw or repairing the hole with wood filler.